Bit Tips Pozidriv
ITM Pozidriv power bits in #1, #2 and #3, in lengths of 1", 2" and 3". Seven bits for Pozidriv screws, with impact-shank and standard 1/4" hex options.
Choosing a Pozidriv bit
Pozidriv screws look a lot like Phillips, but the head has extra tick marks between the main slots and a bit built to match. The range is seven ITM bits in #1, #2 and #3. Lengths are 1" for short inserts and 2" or 3" for reaching. Four are on a 1/4" hex impact shank and three are on a plain 1/4" hex shank. Product titles spell the drive "Posidrive".
Driving tips
Match the bit to the screw. A Phillips bit in a Pozidriv head slips and strips it, and a Pozidriv bit in a Phillips head does the same. Look for the four small tick marks on the screw head to tell them apart. Seat the bit fully, keep the driver straight and press firmly. If the screws are Phillips, use the Phillips bits instead.
Free shipping on orders over $200. Trade accounts can reorder in a click from My Toolbox, or call (833) 438-6657.
Common questions
How can I tell Pozidriv from Phillips?
A Pozidriv head has four small tick marks between the main cross slots. Phillips heads do not. The bits are not interchangeable, so check the head before you pick a bit.
What sizes come in this range?
#1, #2 and #3. #2 comes in 1", 2" and 3" lengths; #1 and #3 come in shorter lengths. Seven bits in total, all ITM.
Do these fit an impact driver?
Four of the seven are on a 1/4" hex impact shank. The other three are on a standard 1/4" hex shank, which is fine for a drill/driver or screw gun.
Know-how for Bit Tips Pozidriv
All guides →
Buying for a crew?
Call 833-438-6657, 8 AM to 4 PM MST. We know the parts, not just the part numbers.